Vistaquest N7227V5 Manuel d'utilisateur télécharger pdf (Page 47)

– 47 –

Programming The Control For Phone Access

1. With at least one addressable keypad (but set to the non-addressable

mode, address 31) connected to the keypad terminals on the control,

power up the system temporarily. If you had previously connected the AC

transformer to the control panel, you need only plug in the transformer (to

120VAC outlet) to power up the system.

2. Enter the programming mode by keying the following on the keypad:

INSTALLER code (4 1 1 1) + 8 + 0.

3. Press

✱

26. VOICE (PHONE) MODULE ACCESS CODE.

If using a 4285 Phone module, enter the 2-digit phone access code as

follows: For first digit, enter 1–9; for second digit, enter # +11 for "

✱

", or

# +12 for "#". Example: if desired access code is 7

✱

, 7 is the first entry,

and # + 11 (for

✱

) is the second entry.

Enter “00” if not using a Phone module (this is the default).

NOTE: a “0” in either digit will disable the phone module.

4. Press

✱

95. RING DETECTION COUNT.

Refer to the chart below and program this field accordingly.

Voice Answering

Module Machine Downloading Field

✱

95 Programming

Yes No No Set for value other than “0” (1–14).

This will enable the control panel to

answer the phone call. Otherwise,

it will not be possible to access the

Phone module.

Yes Yes No Set for a value higher than the

number of rings for which the

answering machine is set.

Example: if the machine is set for 4

rings, use a value of 5 or higher.

This is recommended so that the

Phone module can still be accessed

if the answering machine is turned

off and does not answer the phone

call.

Yes No Yes Set for value other than “0” (1–14).

Yes Yes Yes Enter “15” to bypass the answering

machine. See Important Note below.

Important Note: If “15” is entered in field

✱

95 to bypass an answering machine,

and a 4285 Phone Module is included in the installation, you should note the

following:

When calling in from an off-premises phone (to receive a status report or execute a

command), the user should make the initial call, allow 1 to 3 rings only, and hang

up. Then call in again – the Phone Module will now seize the line, and 2 long tones

will be heard, followed by the usual voice prompt for the 2-digit phone access code.

If this procedure is not followed, Phone Module operation will not be possible.

5. Zone descriptors should also be programmed, regardless of the type of

keypads in use. If this is not done, the Phone module will not annunciate a

description of the zone(s) in alarm, trouble, etc. (the Phone module will

annunciate zone numbers only).

You can enter zone descriptors now using interactive mode

✱

82, or later.

See the

ALPHA DESCRIPTOR PROGRAMMING

section for a detailed

procedure.

6. Exit the programming mode by entering

✱

99.

Perform a preliminary check of the 4285 Phone module, as indicated next.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 87 88

Commentaires sur ces manuels

Pas de commentaire

Vistaquest N7227V5 Manuel d'utilisateur Page 47

Commentaires sur ces manuels